Teledyne LeCroy WaveExpert series Automation Manual - Manual (Page 142)

Chapter Three Control Reference
First source trace for measurements made in 'Eye Measure' mode.
EyeSource1 Enum
Description
Values
C1
C2
C3
C4
M1
M2
M3
M4
Second source trace for measurements made in 'Eye Measure' mode.
EyeSource2 Enum
Description
Values
C1
C2
C3
C4
M1
M2
M3
M4
MEASURE app.Measure.Measure
Names of the forms app.Measure.Measure("Premote").xxxx and app.Measure.Measure("Px").xxxx are aliases of simpler
names which are described in the section of the manual which is devoted to app.Measure. Examples of alias pairs are
as follows -
app.Measure.Measure("Premote").OutResult is equivalent to app.Measure."Premote".OutResult
app.Measure.Measure("Px").Statistics is equivalent to app.Measure.Px.Statistics
Please see under app.Acquisition.Channels("Cx") for a programming example.
PX app.Measure.Px
This set of variables controls the parameters P1 through P8, (when the MeasureMode is "MyMeasure", otherwise these
are predefined) and the statistical results and histicons which depend on them.
ClearSweeps Action
GateByRange Bool
916435 RevA 3-75