Teledyne LeCroy WaveExpert series Automation Manual - Manual (Page 280)

A PPENDIX - A DCOM Setup
6. Click the
Default COM Security
tab. Click the Edit Default button on the Access Permissions section of
the dialog.
Note
: Users sometimes notice the Default Properties and Default COM Security tab names sometimes are interchanged by Windows.
7. The
Access Permissions
dialog is shown. Click the Add button.
• If the PC and Oscilloscope ARE in the same NT domain, this is a User Level configuration. Provide the
exact same user account (username and password) created on the PC (covered previously in this
manual).
• If the PC and Oscilloscope ARE NOT in the same NT domain, this is a Share Level configuration.
Provide the exact same user account (username and password) created on the PC (covered previously
in this manual). However, the username must be preceded by the NT domain name and a backslash \.
Example
: LECROY\John.Smith.
8. Verify the
Allow
check-box is checked on the Access Permissions dialog.
9. Click
OK
on the Access Permissions dialog and Apply, and then OK on the Properties dialog. The
Component Services
should now be showing.
10. Access the following path from Component Services: Component Services Æ Computers Æ My
Computer
Æ DCOM Config. Find and right-click on LeCroyXStreamDSO and select Properties.
A-23
916435 RevA