Teledyne LeCroy WaveExpert series Automation Manual - Manual (Page 59)

C HAPTER T WO Overview
64-bit hexadecimal
int value shown in
XStreamBrowser
VT_DECIMAL
value
returned
from Status
property
StatusDescription Description
0x4000 - 0x200000
1.6384 -
209.7152
reserved
0x400000 419.4304 Not an NRZ Eye Not an NRZ Eye
0x800000 838.8608 Not an RZ Eye Not an RZ Eye
0x1000000 -
0x80000000
1677.7216 -
214748.3648
reserved
0x100000000 429496.7296 Inputs incompatible
Some incompatibility exists between
inputs (e.g. units, frame, sample rate)
0x200000000 858993.4592 Algorithm limits reached Algorithm couldn't converge or some
other algorithmic limitation reached.
0x400000000 1717986.918 Bad settings Combination of settings isn't correct.
0x800000000 3435973.837 Too little data
Not enough data to accurately perform
calculation.
0x1000000000 6871947.674 Too much data Too muchdata to perform calculation.
0x2000000000 13743895.35 Requires uniform horz
interval
Uniform horizontal interval required.
0x4000000000 27487790.69 Bad units Incorrect or invalid units
0x8000000000 54975581.39 Data range too low
Range of data values is too close to the
resolution (e.g. bad signal to noise
ratio).
0x10000000000 109951162.8 Data undersampled Sample rate too low
0x20000000000 219902325.6 Poor statistics Too few samples, e.g. to populate a
data histogram to have enough statistics
0x40000000000 439804651.1 Slow transition time
Transition time to slow, e.g. JTA time
measurement accuracy for clock that
requires fast edges.
0x80000000000 879609302.2 Data resampled Data is resampled
0x100000000000 1759218604 Data interpolated Data is interpolated; e.g. interpolating
missing points in RIS
0x200000000000 3518437209 Measurement scale
imprecise
If all the data falls in the same histogram
bin, one line for trend, one pixel for XY,
etc...
0x400000000000 7036874418 No data available
Data not available (e.g. processing
inputs disconnected or clear sweeps on
cumulative processing).
0x800000000000 14073748836 Some accumulated
results invalid
One or more results or values within the
accumulated result were invalid and
were skipped.
0x1000000000000 28147497671 Insufficient Memory Memory limitations reached, attempted
allocations failed.
916435 RevA 2-23