Teledyne LeCroy WaveExpert series Automation Manual - Manual (Page 279)

A PPENDIX - A DCOM Setup
DCOM System Configuration on Windows Embedded (on the Oscilloscope)
1. Click
Start
Æ Run enter dcomcnfg.exe and press Enter.
Alternatively:
You can click Start Æ Control Panel and double-click Administrative Tools and Component
Services
.
2. Expand
Component Services
by clicking the + plus sign (this may take a few minutes).
3. Expand
Computers
, right-click My Computer, and select Properties.
4. Click the
Options
tab on the Properties display, set the Transaction timeout to 0, and click the Apply
button.
5. Now, click the Default Properties tab and make sure the Enable Distributed COM on this computer
check-box is checked and the Default Authentication Level drop-down is set to Connect.
A-
916435 RevA
22