Teledyne LeCroy WaveExpert series Automation Manual - Manual (Page 149)

Chapter Three Control Reference
RESULT app.Measure.Px.num.Result
OPERATOR app.Measure.Px.Operator
This path specifies that the selected ParamEngine or ArithEngine control variables are "here"
RESULT app.Measure.Px.Out.Result
Properties of the type xxxx.Out.Result.yyyy are those of the last completed acquisition. They are not affected if other
cvars are changed after that acquisition was completed. This distinction between "Out.Result" properties and other
cvars is most important when the trigger mode is Single or Stopped. You should treat "Out.Result" properties as read-
only.
RESULT app.Measure.Px.sdev.Result
STATISTICS app.Measure.Px.Statistics
This set of variables controls the statistical summaries that are provided for all the parameters.
MEMORY app.Memory
Variables of the form app.Memory.xxxx control the memories M1 through M4.
Names of the form app.Memory.Memories("Mx").xxxx are aliases of simpler names which are described in this section
of the manual. Examples of alias pairs are as follows -
app.Memory.Memories("Mx").Out.Result is equivalent to app.Memory.Mx.Out.Result
app.Memory.Memories("Mx").Zoom is equivalent to app.Memory.Mx.Zoom
3-82 916435 RevA