beautypg.com

Select sound commands, Show pause commands, Sa5a5” [nn] (card address) autodownload – Gilderfluke&Co Mp3-50 Audio & Show Controllers User Manual

Page 71: Realtime update

background image

Select Sound Commands:

“^t” [nn] (Card Address) [nn] (sound#)

Select Sound Track:

“^u” [nn] (sound#)

Select Sound Global:

These commands are availible on firmware revisions 1.15

and later:

Up to two hundred fifty-five different sounds can be

stored on a single Mp3-50/8 or Mp3-50/40. These commands
can be used to select an individual sound on the selected Mp3-
50/8(s)
or Mp3-50/40(s). Individual sounds can be requested with
a range of 01 to FFH. Once a sound is selected, it will be played
immediately. The sound number must be entered as a two digit
hexadecimal number.

Show Pause Commands:

“<” [nn] (card address)

Pause Show:

“>” [nn] (card address)

Continue Show:

Any show can be paused at any point during its playback. The

outputs are frozen at the levels they were at the instant the PAUSE
command is received.

The CONTINUE command will resume any show playing which

has previously been PAUSED.

“sA5A5” [nn] (card address) AutoDownload:

This is the format of the file that the Mp3-50/8 or Mp3-50/40

will receive and load into its 'Flash' memory.

An AutoDownload file is a binary file. Any AutoDownload file

that has previously been saved can be sent to a Mp3-50/8 or
Mp3-50/40 by selecting the ‘send binary file’ on your modem pro-
gram and selecting the AutoDownload file for sending. You must
be sure that the modem program has not been set to ‘gobble’
any special characters (carriage returns, line feeds, etc.).

The Hyper Terminal program that comes with Windows ‘95 and

‘98 will not work for sending AutoDownloads. For some strange
reason it has been written to randomly change any binary value
that is larger than one hundred twenty-seven.

“~”

RealTime Update:

This command sets the Mp3-50/8 or Mp3-50/40 into a mode

where it will update the outputs in RealTime from the data re-
ceived through the serial port. The Mp3-50/8 or Mp3-50/40 uses
this command to update the outputs in real time.

G

ILDERFLUKE

& C

O

.205 S

OUTH

F

LOWER

S

TREET

B

URBANK

, C

ALIFORNIA

91502 818/840-9484 800/776-5972

FAX

818/840-9485

E

AST

C

OAST

/F

LORIDA

O

FFICE

7041 G

RAND

N

ATIONAL

D

RIVE

S

UITE

128d O

RLANDO

, F

L

. 32819 407/354-5954

FAX

407/354-5955

63 of 119

This manual is related to the following products: