Gilderfluke&Co Mp3-50 Audio & Show Controllers - Manual (Page 106)

are:
1) Do not change Playback Level: This leaves the audio
levels where they were before.
2) Fade to Full In: This ramps the audio towards the ‘full’
level. The ‘In’ in the command refers to the time it will
take to ramp to the selected level. Ramp rates avail-
able are between 0 and 9.9 seconds. The audio level
is set on the Audio tab, or by the RealTime level con-
trol, if this option has been selected.
3) Fade to Zero In: This ramps the audio back towards
the a fully muted level. The ‘In’ in the command refers
to the time it will take to ramp to the selected level.
Ramp rates available are between 0 and 9.9 sec-
onds.
4) Fade to ‘Half Mute’ In: This ramps the audio towards
the level which has been set for the ‘half muted’ level.
The ‘In’ in the command refers to the time it will take
to ramp to the selected level. Ramp rates available
are between 0 and 9.9 seconds. The audio level is set
on the Audio tab, or scaled from the RealTime level
control, if this option has been selected.
Start Playing: This series of popups allows you to select and play
an AudioFile on this input/edge. The tracks can me selected
form all of those on the SmartMedia card, or from one of
the eight PlayLists:
Within the PlayList or SmartMedia card you selected in the last
G
ILDERFLUKE
& C
O
.• 205 S
OUTH
F
LOWER
S
TREET
• B
URBANK
, C
ALIFORNIA
91502 • 818/840-9484 • 800/776-5972 •
FAX
818/840-9485
E
AST
C
OAST
/F
LORIDA
O
FFICE
• 7041 G
RAND
N
ATIONAL
D
RIVE
• S
UITE
128d • O
RLANDO
, F
L
. 32819 • 407/354-5954 •
FAX
407/354-5955
98 of 119