Gilderfluke&Co Mp3-50 Audio & Show Controllers - Manual (Page 69)

second time.
“j5AA5” [nn] (card address) Card Reset:
This command will erase the 'Flash' memory on the Mp3-50/8
or Mp3-50/40. The Mp3-50/8 or Mp3-50/40 will also determine
the type and quantity of memory chips installed and report this
and the software revision number when it accepts this command.
Start Commands:
“t” [nn] (card address) Start Track:
“u” Start Global:
These commands start the animation playing on the Mp3-
50/8 or Mp3-50/40 (s) addressed by the command. The shows will
always start from the beginning. If an addressed Mp3-50/8 or
Mp3-50/40 is looping shows, it will have the ‘LOOPING SHOWS’
flag reset.
If the Mp3-50/8 or Mp3-50/40 receives a start command
after it has received a request for a specific show, it will play that
show. Otherwise it will play the show that has been set as the
‘next’ show for the show which is currently playing (or most recent-
ly played show if it is not currently playing). If this is the first show
played after a Mp3-50/8 or Mp3-50/40 is reset, it will play the
show which has been set as the ‘first’ show during the AutoDown-
load. Requests for specific shows can come only from the serial
port.
When shows are downloaded to the Mp3-50/8 or Mp3-50/40,
they can be set to ignore additional start commands while they
are playing. This allows individual shows to be ‘stepped’ upon or
not. If the Mp3-50/8 or Mp3-50/40 is already playing a show
which has this option set, it will ignore this command.
Stop Commands:
“x” [nn] (card address) Stop Track:
“y” Stop Global:
These commands stop the selected Mp3-50/8 or Mp3-50/40
(s) unconditionally. The stop takes place at the current frame
being played.
G
ILDERFLUKE
& C
O
.• 205 S
OUTH
F
LOWER
S
TREET
• B
URBANK
, C
ALIFORNIA
91502 • 818/840-9484 • 800/776-5972 •
FAX
818/840-9485
E
AST
C
OAST
/F
LORIDA
O
FFICE
• 7041 G
RAND
N
ATIONAL
D
RIVE
• S
UITE
128d • O
RLANDO
, F
L
. 32819 • 407/354-5954 •
FAX
407/354-5955
61 of 119