Micromod MOD: 1800P - MOD 30ML Identity Module (Version 2) Algorithms, Tables and Sequential Logic Functions - Manual (Page 90)

Logic Functions - Book 2
SUPERVISORY MESSAGE BLOCK
8-82
05 Message failure error (FSUPP) ........................................................................................ CWR
Indicates whether failure diagnostic error is suppressed.
ENABLE 0 Failure diagnostic error is enabled. When this diagnostic is detected,
the diagnostic message SUPERVISORY MESSAGE ERROR is
reported.
SUPPRESS 1 Failure diagnostic error is suppressed.
06 Unacked Failure diag (FUNACK)......................................................................................– WR
If the failure diagnostic error is enabled, the unacknowledged status indicates if the diagnostic
error is or is not acknowledged.
NO 0 Diagnostic error is acknowledged.
YES 1 Diagnostic error is unacknowledged.
07 Unacked Failure Diag Quality (FUNACKQ) .....................................................................– WR
If the failure diagnostic error is enabled, this status indicates if the quality of the
unacknowledged diagnostic is GOOD or BAD. Only writeable in DEBUG.
GOOD 0 Quality when this block (or its controlling loop) is RUN or HOLD.
BAD 1 Quality when this block (or its controlling loop) is OFF.
08 Failure Counter (FCNT) ....................................................................................................– WR
Indicates the number of times the message has failed to go to completion after having been
triggered.
09 Failure Counter Quality (FCNTQ) ....................................................................................– WR
Indicates the quality of the failure count field.
GOOD 0 Quality when this block (or its controlling loop) is RUN or HOLD.
BAD 1 Quality when this block (or its controlling loop) is OFF.
10 Send Command (SEND) ...................................................................................................– WR
Manual trigger for send command. Signal is edge triggered. The send command triggers the
block when received, regardless of the loop or block state. This is a push button attribute; its
value is normally 0, when triggered or manually written its value goes momentarily to 1, then
returns to 0. This field is always read as 0.
11 Active (A)..................................................................................................................................... – W
Specifies whether the transaction has been completed. The active flag is set when the
message is triggered and remains set until the transaction is complete or until failure is
determined.
NO 0 The transaction has been completed or failure has occurred.
YES 1 The transaction is not complete.
12 Active Quality (AQ) ...........................................................................................................– WR
If the transmission of messages is enabled, this status indicates if the quality of the Active flag
is GOOD or BAD. Only writeable in DEBUG.
GOOD 0 Quality when this block (or its controlling loop) is RUN or HOLD.
BAD 1 Quality when this block (or its controlling loop) is OFF.