Micromod MOD: 1800P - MOD 30ML Identity Module (Version 2) Algorithms, Tables and Sequential Logic Functions - Manual (Page 76)

Logic Functions - Book 2
NOTIFICATION/REQUEST MESSAGE BLOCK
8-68
06 Unacked Timeout Diagnostic (TOUNACK)......................................................................– WR
If the timeout diagnostic error is enabled, the unacknowledged status indicates if the
diagnostic error is or is not acknowledged.
NO 0 Diagnostic error is acknowledged.
YES 1 Diagnostic error is unacknowledged.
07 Unacked Timeout Diag Quality (TOUNACKQ) ................................................................– WR
If the timeout diagnostic error is enabled, this status indicates if the quality of the
unacknowledged diagnostic is GOOD or BAD. Only writeable in DEBUG.
GOOD 0 Quality when this block (or its controlling loop) is RUN or HOLD.
BAD 1 Quality when this block (or its controlling loop) is OFF.
08 Active Timeout Diag (TOACT)..........................................................................................– WR
If the timeout diagnostic error is enabled, the active status indicates if the diagnostic error is
active even after acknowledgement.
CLEAR 0 Diagnostic error is not active.
ACTIVE 1 Diagnostic error is active.
09 Active Timeout Diag Quality (TOACTQ)..........................................................................– WR
If the timeout diagnostic error is enabled, this status indicates if the quality of the active
diagnostic is GOOD or BAD. Only writeable in DEBUG.
GOOD 0 Quality when this block (or its controlling loop) is RUN or HOLD.
BAD 1 Quality when this block (or its controlling loop) is OFF.
10 Send Command (SEND) ...................................................................................................– WR
Manual trigger for send command. Signal is edge triggered. The send command triggers the
block when received, regardless of the loop or block state.
11 Suppress Notification? (SUPP) ....................................................................................... CWR
Event action suppression flag.
NO 0 Transmission of messages is not suppressed.
YES 1 Transmission of messages is suppressed. The Send Source input is
ignored and outputs will be reset and remain in their normal state.
Messages can only be triggered using the manual send command.
12 Message Unacked (U) .......................................................................................................– WR
Message unacknowledged flag. When TRUE, a message remains unacknowledged.
NO 0 A message is acknowledged. This flag is set back to FALSE upon
any of the following events: Suppress Notification flag set to YES, a
global acknowledge via a System Event block, a notification/request
acknowledge via a System Event block, an alarm acknowledge
source, an operator write of FALSE to this field, a write to the data
field while a response is pending.
YES 1 A message is unacknowledged. This flag is set TRUE when the
Send Command is triggered.