Luminex 100 IS Version 2.2 - Manual (Page 54)

Luminex 100 IS Developer Guide to x MAP Technology Version 2.2 x MAP Technology
48 PN 89-00002-00-032 Rev. A
Figure 31. Open Reagent Product Dialog Box
9. Highlight the product to add to the template. The test and reagent
information appear for the product highlighted to help you make
your selection. You can not edit the information here.
Note: If the desired product is not present in the list, select New
to create a new product.
10. Select the product that you want to add to the template and click
Open.
11. The system applies the standard and/or controls in the product to
the template. Edit the Test Name and Test Units on the
following Template Setup Wizard dialog box if needed. The
changes you make are effective for this template only; changes
are not made to the original product.
The Apply Unit button applies the same unit that you entered in
the first line to all other tests.
Note: You can use the same product in multiple templates.
However, you can only have one product per template.
12. At the Template Setup Wizard dialog, select the Bead Id for
each test listed. Type the Bead Id or select it from the drop-
This list shows all saved
products. Select the desired
product from the list
Cyberxlabs xt
Cyberxlabs xt
Cyberxlabs xt
Cyberxlabs xt
Cyberxlabs xt
Cyberxlabs xt