Luminex 100 IS Version 2.2 User Manual
Page 40
Luminex
100
IS Developer Guide to
x
MAP Technology Version 2.2
x
MAP
Technology
34
PN 89-00002-00-032 Rev. A
Figure 21. Create New Product—Create Control Products
3. Select Control.
4. Enter the Product Number, Product Name, and Manufacturer
Name for the product.
5. Enter the Number of Tests for this product and press Enter key.
Each test represents a bead set (the bead ID for each test is
selected when creating the template using this product).
6. Enter the Test Name (analyte) and Test Units used for each test.
Note:
If the test name is similar and the units are the same for
each test, after entering the first test name and unit, click the
Apply Suffix or Apply Unit buttons as appropriate.
Apply Suffix—this button applies the number one to the first
test name. For each successive test name it applies the test name
and number at one increment higher than the previous test name.
For example: Suffix = Protein, then Test 1 is Protein 1, Test 2 is
Protein 2, and so on.
Select Control
Cyberxlabs xt
Cyberxlabs xt