Luminex 100 IS Version 2.2 - Manual (Page 42)

Luminex 100 IS Developer Guide to x MAP Technology Version 2.2 x MAP Technology
36 PN 89-00002-00-032 Rev. A
Figure 22. Create New Product—Create Products With
Standards and Controls
4. Enter the Product Number, Product Name, and Manufacturer
Name for one of the product.
5. Enter the Number of Tests for this product and press Enter key.
Each test represents a bead set (the bead ID for each test is
selected when you create the template using this product).
6. Enter the Test Name (analyte) and Test Units used for each test.
Note: If the test name is similar and the units are the same for
each test, after entering the first test name and unit, click the
Apply Suffix or Apply Unit buttons as appropriate.
Select Both
Cyberxlabs xt
Cyberxlabs xt
Cybexrlabs xt
Cyberxlabs xt
Cyberxlabs xt