Luminex 100 IS Version 2.2 - Manual (Page 41)

x MAP Technology Create Products
PN 89-00002-00-032 Rev. A 35
Apply Unit—this button applies the same unit value that you
entered on the first line to all other tests. For example, if you
enter the mg/uL value for the first Test Unit, then select the
Apply Unit button to make all test units mg/uL.
7. Enter the Number of Controls (assay) for this product and press
Enter key.
8. Enter the Reagent Name for each control in this product. Each
control reagent must test for every analyte (bead set) used in the
assay. See example in Figure 22.
Note: If the reagent names are similar, click the Apply Suffix
button to ensure each name is unique.
9. After entering all the information, check it carefully. When all
the information is correct, click Save to save the product.
10. Click Close.
Assay Standards and
Controls (Both) ‹ To create a product that consists of assay standards and controls:
1. Click the Create Product button on the toolbar. The Create New
Product dialog box appears listing the existing products. See
Figure 22.
2. Select New to enter a new product into the system. You do not
need to select the New button for the first time.
3. Select Both.