Asus GigaX3124 - Manual (Page 56)

GigaX3124 Layer3 Switch CLI Command Reference
31
Description Use the duplex interface configuration command on the switch
stack or on a standalone switch to specify the duplex mode of
operation for Fast Ethernet and Gigabit Ethernet ports. Use the
no form of this command to return the port to its default value.
Examples ASUS(config-if)# duplex full
3.6 flowcontrol (both| rx| tx)
Syntax flowcontrol (both| rx| tx)
Parameters both Allow the interface to receive+transmit pause frames
rx Allow the interface to receive pause frames
tx Allow the interface to transmit pause frames
Command Mode Interface configuration mode
No/clear
no flowcontrol
Show show interface IFNAME
Default The default is both
Description This command sets the interface flowcontrol method.
Examples ASUS(config-if)# flowcontrol both
3.7 ingress-filter (enable|disable)
Syntax ingress-filter (enable|disable)
Parameters enable Allow non-VLAN-member tagged packets forwarding
disable Drop non-VLAN-member tagged packets
Command Mode Interface configuration mode
No/clear
Show
show interface IFNAME
Default The default is enable
Description This command sets the IEEE 802.1Q tagged frames filtering for
the interface.
Examples ASUS(config-if)# ingress-filter disable