Asus GigaX3124 - Manual (Page 27)

GigaX3124 Layer3 Switch CLI Command Reference
2
• Config-vlan
• Mac access-list extended
• IP standard access-list
• IP extended access-list
• Policy-map configuration
• Policy-map-class configuration
• Config-router
When you start a session on the switch, you begin in user mode, often called
user EXEC mode, which has only a limited subset of the commands. To
access all commands and modes, you must first enter privileged EXEC mode.
From privileged mode, you can enter any EXEC command or enter global
configuration mode. Most of the EXEC commands are one-time commands,
such as show commands, which show the current configuration status, and no
commands, which clear counters or interfaces.
You can use the Config-vlan (virtual LAN) and the various configuration
modes to make changes to the running configuration. To access the various
configuration modes, you must start at global configuration mode. From global
configuration mode, you can enter interface and line configuration modes.
Table 1-1 describes how to access each mode, the prompt you see in that mode,
and how to exit the mode. The examples in the table use the host name ASUS.
Table 1-1: Command Modes Summary
C o m m a n d
mode
Access method Prompt Exit or Access Next
Mode.
User EXEC This is the first level
of access.(For the
switch) Change termi-
nal settings, perform
basic tasks, and list
system information.
ASUS> Exit to enter the EXIT
command. To enter privi-
leged EXEC mode, enter
the enable command.
Privileged
EXEC
From user EXEC
mode, enter the
enable command.
ASUS# To exit to user EXEC mode,
enter the disable command.
To enter global configuration
mode, enter the configure
terminal command.