Asus GigaX3124 - Manual (Page 212)

GigaX3124 Layer3 Switch CLI Command Reference
187
[IFNAME] Egress interface name
Command Mode IP extended access-list mode
No/clear
no (permit|deny) icmp host IPADDR IPADDR MASK <0-255>
[IFNAME]
Show show access-lists [ACLNAME]
Default
Description
This command specifies one or more conditions denied or
permitted to decide if the packet is forwarded or dropped.
Examples ASUS(config-ext-acl)# permit icmp host 10.0.0.1 10.0.0.2 0.0.0.0
2 [gi1/0/1]
13.112 (permit|deny) icmp IPADDR MASK host
IPADDR <0-255> [IFNAME]
Syntax (permit|deny) icmp IPADDR MASK host IPADDR <0-255>
[IFNAME]
Parameters permit Specify packets to forward
deny Specify packets to reject.
icmp Internet Control Message Protocol
IPADDR Source address
MASK Source wildcard bits
host A single destination host
IPADDR Destination address
<0-255> ICMP message type
[IFNAME] Egress interface name
Command Mode IP extended access-list mode
No/clear
no (permit|deny) icmp IPADDR MASK host IPADDR <0-255>
[IFNAME]
Show show access-lists [ACLNAME]
Default
Description
This command specifies one or more conditions denied or
permitted to decide if the packet is forwarded or dropped.