Asus GigaX3124 - Manual (Page 292)

GigaX3124 Layer3 Switch CLI Command Reference
267
Default The default is to send only version 2.
Description Version can be `1’, `2’, `1 2’. This configuration command
overrides the router’s rip version setting. The command will
enable the selected interface to send packets with RIP Version 1,
RIP Version 2, or both. In the case of ‘1 2’, packets will be both
broadcast and multicast.
Examples ASUS(config-if)# ip rip send version 1
24.9 ip split-horizon [poisoned-reverse]
Syntax ip split-horizon [poisoned-reverse]
Parameters split-horizon to enable the function of split-horizon
[poisoned-reverse] With poisoned-reverse
Command Mode Interface configuration mode
No/clear
no ip split-horizon [poisoned-reverse]
Show show running-config
Default Enable split-horizon
Description Control split-horizon on the interface. Default is ip split-horizon.
If you don’t perform split-horizon on the interface, please specify
no ip split-horizon.
Examples ASUS(config-if)# ip rip split-horizon poisoned-reverse
24.10 neighbor A.B.C.D
Syntax neighbor A.B.C.D
Parameters A.B.C.D Neighbor router address
Command Mode Config-router mode
No/clear
no neighbor A.B.C.D
Show show ip rip status
Default
Description
Specify RIP neighbor. When a neighbor doesn’t understand
multicast, this command is used to specify neighbors. In some
cases, not all routers will be able to understand multicasting,
where packets are sent to a network or a group of addresses. In
a situation where a neighbor cannot process multicast packets,