Asus GigaX3124 - Manual (Page 305)

GigaX3124 Layer3 Switch CLI Command Reference
280
transmit-delay Link state transmit delay
dead-interval Interval after which a neighbor is declared dead
<1-65535> Time value, seconds
Command Mode Config-router mode
No/clear
no area (A.B.C.D|<0-4294967295>) virtual-link A.B.C.D (hello-
interval| retransmit-interval| transmit-delay| dead-interval)
Show show running-config
Default Hello-interval is 10 sec, retransmit-interval is 5 sec, transmit-
delay 40 sec, dead-interval 40 sec
Description To configure a virtual link router for the specified area and set
hello interval, retransmit interval, transmit delay or dead interval.
Examples ASUS(config-router)# area 0.0.0.2 virtual-link 10.1.1.2 hello-
interval 20
ASUS(config-router)# area 0.0.0.2 virtual-link 10.1.1.2 hello-
interval 20 retransmit-interval 10 transmit-delay 50 dead-interval
50
25.13 area (A.B.C.D| <0-4294967295>) virtual-link
A.B.C.D authentication
Syntax area (A.B.C.D|<0-4294967295>) virtual-link A.B.C.D
authentication
Parameters A.B.C.D OSPF area ID in IP address format
<0-4294967295> OSPF area ID as a decimal value
(ID 0.0.0.2 equals ID 2)
virtual-link Configure a virtual link
A.B.C.D Router ID of the remote ABR
authentication Enable authentication on this virtual link
Command Mode Config-router mode
No/clear
no area (A.B.C.D|<0-4294967295>) virtual-link A.B.C.D
authentication
Show show running-config
Default Not enable authentication