TC Electronic Broadcast 6000 - Manual (Page 80)

Delay-2
76 System 6000 MKII Algorithms
Delay-2 algorithm – FB
Modulation page
Feedback-1
Range: -100 to 100 %
The percent of positive phase and negative
phase feedback for channel 1 feedback path in-
cludes Lo Cut and Hi Cut filters.
Feedback- 2
Range: -100 to 100 %
The percent of positive phase and negative
phase feedback for channel 2 feedback path in-
cludes Lo Cut and Hi Cut filters.
XFB 1>2
Range: -100 to 100 %
The percent of crossfeed from channel 1 Output
to ch. 2 Input.
XFB 2>1
Range: -100 to 100 %
The percent of crossfeed from channel 2 Output
to ch. 1 Input.
Feedback EQ
Lo FB Att
Range: -40.0 to 0.0 dB
Gain for Lo Xover filter. Adjust in 0.5 dB.
Hi FB Att
Range: -40.0 to 0.0 dB
Gain for Hi Xover filter. Adjusts in 0.5 dB.
Lo Xover
Range: 20 Hz to flat
Frequency for 6 dB pr. octave Lo Cut filter.
Hi Xover
Range: 20 Hz to flat
Frequency for 6 dB pr. octave Hi Cut filter.
Modulation
Speed
Range: 0.1 Hz to 10 Hz
Controls the rate of modulation sweeps in a
range from 1 sweep every 10 seconds to 10
sweeps per second.
Depth
Range: 0 to 100 %
Determines how wide a modulation sweep is
produced.
If you do not want to modulate the effect signal,
set this parameter to 0 %.
LFO Phase
Range: 0° – 90° – 180°
Determines the sine wave modulation phase shift
between left and right channel. At 0° the left and
right channel will move in sync. At 180° the mod-
ulation will move against each other.