TC Electronic Broadcast 6000 - Manual (Page 204)

VP-2 Stereo
200 System 6000 MKII Algorithms
Factor/Adjust
Range: 1, 10 or 100
The Factor parameter is a multiplier factor for the
Adjust handles. Use the Adjust handles to fine-
tune the transpose value.
Pitch Splicing
The Splicing parameters are used to optimize
how the pitch brains compute the splice points.
If very short Delay times are used, audio quality
trade-offs must be expected.
Max Delay – Left & Right
Range: 0 to 100 %
Sets the maximum delay used for pitch change
purposes.
If low processing Delay is important, this pa-
rameter should be set at minimum value when
listening for splicing artifacts passing the lowest
expected audio frequency.
The Delay found in the Effect section adds to the
Max Delay.
Splice Size
Range: 0 to 100 %
Sets the maximum timing variation allowed when
the pitch brain looks for perfect splice points.
If splicing intervals have to be kept constant, this
control should be turned towards low values.
Pitch Splicing Illustration
VP-2 Stereo algorithm
– effect page
VP-2 Stereo algorithm – effect page
A few effects can be added to the processed
signal within the Pitch algorithm.
Effect Mode
Range: On, Off
Enables/disables the Effect mode.
Delay
Delay Left
Range: 0 to 310 ms
Sets the Delay time for the processed signal in
left channel.
Delay Right
Range: 0 to 310 ms
Sets the Delay time for the processed signal in
right channel.
Feedback Levels
Feedback L
Range: 0 to 100 %
Determines how much processed signal from
the left channel that is fed back to the left Input
channel of the algorithm.
Feedback R
Range: 0 to 100 %
Determines how much processed signal from
the right channel that is fed back to the right In-
put channel of the algorithm.