TC Electronic Broadcast 6000 - Manual (Page 51)

VSS™ 6.1 Reverb
English Manual 47
Location
Location Type
Select between different Locations. Both the
Early Reflection and Diffuse Field characteristics
are changed when switching Location to give the
optimal starting point for further adjustments.
Variation
For some of the Locations it is also possible to
select between different variations of the same
Location. Experiment and select the most ap-
propriate Variation type for your application.
Output Format
Output Format
Selects Output (and Input) Format. 5.1 is nor-
mally chosen for the domestic speaker arrange-
ment, ITU 775, while 6.1 is selected for Cinema
formats like DTS ES and Dolby EX. 6.1 mode may
also be chosen for SACD 6.0 reproduction.
Note: The algorithm I/O assignments change
when this parameter is operated.
Center Channel
Range: Off/On/Pseudo On/ Reverb Only
Enables on/off switching of the Center speaker in
the two multi-channel modes.The Phantom set-
ting is a patent pending feature that sometimes
makes the Center speaker integrate in a more
“music friendly” than a standard On setting.
Levels
In Level
Range: Off to 0 dB
Master Input Level Control for all channels, wet
and dry signals.
Out Level
Range: Off to 0 dB
Master Output Level Control for all channels, wet
and dry signals.
Dry Level
Range: Off to 0 dB
Sets the amount of Dry signal that is passed
through the algorithm. Off equals a kill-dry set-
ting for a send/return configuration, and is the
default on Factory presets.
VSS™ 6.1 Reverb algorithm
– color page
VSS™ 6.1 Reverb algorithm – color page
There is a full set of the parameters described
below for both the Front and Surround channels.
Select Front or Surround parameters using the
two tabs “Front” and “Surround”, or link all five
channels by activating the Link button.
Link
With Link enabled, there is only one set of pa-
rameters on the Color page covering all chan-
nels. When pressing Link a pop-up display
prompts you whether you wish to copy all Front
channel settings to the Surround channels. If you
accept, the settings for the Surround channels
are overwritten.
Reverb Front
Lo Cut
Range: 20 Hz to 200 Hz
Determines the Lo Cut frequency.
Attenuation amount is controlled via the Lo
Damp parameter.
Lo Damp
Range: 0 to -18 dB
Attenuation of the frequencies below the select-
ed frequency via the Lo Cut parameter.