TC Electronic Broadcast 6000 - Manual (Page 29)

Reverb-2
English Manual 25
Hi Decay
Range: 0.01 to 2.00 times
Multiplier for the high frequencies. If Hi Decay
e.g. is set to 0.5, the Hi Decay time is half that
of the nominal Decay setting. This parameter re-
sponds according to the Hi xOver setting.
Lo Xover
Range: 20 Hz to flat
Sets the crossover frequency for the Decay xLo
time multiplier in 1/3-octave steps.
Hi Xover
Range: 20 Hz to flat
Sets the crossover frequency for the Decay x Hi
multiplier in 1/3-octave steps.
Width
Range: 0 to 100 %
Sets the apparent stereo width of the diffuse
field of the algorithm. At “0” the diffuse field
will appear to be coming mainly from the center
(mono compatible), whereas with Rev Width set
to ‘100’ the L/R reverberators are independent.
Diffuse
Range: 1 to 25
Imposes the characteristics of the Early Reflec-
tions on the later reverberation. In order to set
the Rev Diffuse properly, set the Early Lev pa-
rameter to off while adjusting the
Rev Diffuse parameter. The Rev Diffuse param-
eter is best judged using continuous signals like
vocal or guitars.