TC Electronic Broadcast 6000 - Manual (Page 16)

Core-2
12 System 6000 MKII Algorithms
In Level
Range: Off to 0.0 dB
Sets the level of the Input to the Reverb in 0.5 dB
steps.
Out Level
Range: Off to 0.0 dB
Sets the Output level of the Reverb in 0.5 dB
steps.
Rev Core-2 algorithm
– reverb page
Rev Core-2 algorithm – reverb page
Early Reflections
Shape
Range: Hall, Fan Prism, H Shoe, Club and Small.
Select one of the above to simulate a specific
room shape.
Size
Range: 0.040 to 4.000 s
Scales the dimensions of the simulated space
depending on the SHAPE chosen. The specific
room that is being simulated is scaled 1:1 at
SIZE =1.00. This can then be scaled up or down.
Provided that the predelay setting is relatively
short, the corresponding volume of the simulat-
ed space is changed radically with this control.
Xfeed
Range: On/off
With this parameter switched off, the Cross-
feeds in the Early Reflections will be killed. With
Xfeed set to off, and the Width parameter set to
100 %, a true stereo Reverb is created. The ef-
fect from the left and the right channel will be
generated totally independently. The feature is
especially applicable for the film industry and
post production suites.
Reverb
Lo Decay
Range: 0.01 to 2.5 times
Relative Decay time multiplier for low frequen-
cies.
Lo Xover
Range: 20 Hz to flat
Sets the frequency at which the transition from
the low to the low-mid frequencies takes place.
Hi Decay
Range: 0.01 to 2.0 times
Multiplier for the high frequencies. If Hi Decay is
set to 0.5, the Hi Decay time is half that of the
nominal Decay setting.
Hi Xover
Range: 20 Hz to flat
Sets the frequency at which the transition from
the mid frequencies to the high frequencies
takes place.
Width
Range: 0 to 100 %
Sets the apparent stereo width of the reverberat-
ing part of the algorithm. At “0” the diffuse field
will appear to be coming mainly from the cen-
ter (mono compatible), whereas with Width set
to “100” the L/R reverberators are independent.
Hi Cut Freq
Range: 500 Hz to flat
Rolls off the top end as it enters the Reverb Dif-
fuse Field. Use this parameter to “darken” the
room.
Hi Cut Att
Range: -40.0 to 0.0 dB
The attenuation control sets the high frequency
roll determined by the Hi Cut Freq. parameter.