Veris Industries FSRxxxx SERIES Install - Manual

FLOW SENSORS
Z205739-0D PAGE 1 ©2013 Veris Industries USA 800.354.8556 or +1.503.598.4564 / [email protected] 05131
Alta Labs, Enercept, Enspector, Hawkeye, Trustat, Aerospond, Veris, and the Veris ‘V’ logo are trademarks or registered trademarks of Veris Industries, L.L.C. in the USA and/or other countries.
TM
INSTALLATION GUIDE
Ultrasonic Flow Meter
FSRxxxx SERIES
DIMENSIONS
6.0”
(153 mm)
4.1”
(105 mm)
4.3”
(110 mm)
2.1”
(53 mm)
6.4”
(163 mm)
1.4”
(35 mm)
 0.75”
(19 mm)
2x  0.5”
(13 mm)
PRODUCT IDENTIFICATION
Monitor: FSR Series
Transducers: FST1, FST2, FST3, FST4, FST5
FSR Monitor
NOTICE
• This product is not intended for life or safety applications.
• Do not install this product in hazardous or classified locations
other than those listed in Specifications.
• Read and understand the instructions before installing
this product.
• Turn off all power supplying equipment before working on it.
• The installer is responsible for conformance to all applicable codes.
No responsibility is assumed by Veris Industries for any consequences arising out of the
use of this material.
HAZARD OF ELECTRIC SHOCK, EXPLOSION, OR ARC FLASH
• Follow safe electrical work practices. See NFPA 70E in the USA, or applicable local codes.
• This equipment must only be installed and serviced by qualified electrical personnel.
• Read, understand and follow the instructions before installing this product.
• Turn off all power supplying equipment before working on or inside the equipment.
• Use a properly rated voltage sensing device to confirm power is off.
DO NOT DEPEND ON THIS PRODUCT FOR VOLTAGE INDICATION
Failure to follow these instructions will result in death or serious injury.
DANGER
A qualified person is one who has skills and knowledge related to the construction and
operation of this electrical equipment and the installation, and has received safety
training to recognize and avoid the hazards involved. NEC2009 Article 100
No responsibility is assumed by Veris Industries for any consequences arising out of the
use of this material.
FSR
FST4, 5
FST1, 2, 3
Temp Sensors
Note: Do not cut transducer cables to alter length. This will void the
factory warranty. Cables are available in several lengths. Assess the
installation location prior to ordering to determine the optimum length.
If the wrong length is ordered, contact the factory.