EVS IPDirector IPD XEDIO PLUGIN Version 6.0 - January 2013 User Manual - Manual (Page 172)

Issue 6.0.B IPD Xedio Plugin Version 6.0 – User Manual
EVS Broadcast Equipment – January 2013
162
9.4 Conversion Effects
9.4.1 Introduction
Each clip can be converted by the software in Xedio CleanEdit to match the format that
the timeline is using. Conversion can be from and to 4:3 and 16:9 with Pan & Scan and
Letterbox modes supported.
When you have created the Edit, you have selected the aspect ratio for the edit (or it was
non-editable, as for 16:9 with HD video standards). Depending on the aspect ratio for the
edit, you have selected a default conversion type.
You can change the mode used for the selected conversion type (for example PS,
instead of the default conversion type which was LB), by adding a conversion effects to a
clip or to several clips between a mark IN and mark OUT. You will not be able to change
the conversion type itself since it is set at the beginning and has to remain unchanged in
the whole edit.
9.4.2 Changing the Mode for the Conversion
Type
To change the mode for the conversion type for one or several clips, proceed as follows:
1. Select the clips where to apply the effects in one of the following ways:
o To define an effect on one clip, click the requested clip
o To define an effect on several clips, add a mark IN and mark OUT that covers the
first and the last clip.
2. Right-click to access the contextual menu.