EVS IPDirector IPD XEDIO PLUGIN Version 6.0 - January 2013 User Manual - Manual (Page 129)

IPD Xedio Plugin Version 6.0 – User Manual
EVS Broadcast Equipment – January 2013
Issue 6.0.B
119
Methods
Depending on the expected result, you can proceed in three different ways:
•
Drag the clip to be added to the beginning of the blank area:
The IN point of the clip is matched to the beginning of the blank area.
•
Drag the clip anywhere in the blank area
The IN point of the clip to be added will be dropped where you have released the
mouse.
•
Drag the clip in the blank area, while pressing the CTRL key:
The OUT point of the clip to be added will be matched to the end of the blank area
•
Drag the clip in the blank area, while pressing the ALT key:
If the clip is… Then…
greater than the hole in the
timeline The clip speed will be decreased to match the blank
area.
smaller than the hole in the
timeline The clip speed will be increased to match the blank
area.
The following criteria must be met:
•
the parameter Can Accelerate must have been
enabled in Xedio Manager > Softwares > Parameter
Profiles > CleanEdit.
•
the maximal speed, set with the “Max Fast Motion
Speed” parameter, must not be exceeded.
Example
The following screenshots show the situation before, during and after the drag-and-drop
operation using the blank fill option. In this case, the clip is dropped at the beginning of
the blank area.
Before