Playing back a clip, Playback speed features, How to play back a clip – EVS MulticamLSM Version 11.00 Operating Manual User Manual

Page 50: Recall and playback of growing clips, 4 playing back a clip, 5 recall and playback of growing clips

Issue

11.00.C

Multicam - Version 11.00 – Operating Manual

EVS Broadcast Equipment SA – April 2012

9.2.4

Playing Back a Clip

Playback Speed Features

You can play back a clip using several playback speed features explained above in this

user manual. This section summarizes the various playback speed features and refers to

more detailed sections on these features:

•

Playback of a clip at the default playback speed using the

PLAY key

•

Playback of a clip at a speed varying from 0% to 100% using the lever in a basic way

•

Playback of a clip at a speed varying from 0% to a maximum speed defined in the

PGM Speed/Var max parameter (p.9.1 F3) in the Operational Setup menu on the

Remote Panel.
To use this feature, you need to activate the

VarMax option available from the

secondary menu in PGM/PRV mode. For more information, refer to the section

‘PgmSpd/VarMax’, on page 26.

•

Playback of a clip at a given predefined speed defined in the

PGM Speed/Var max

parameter (p.9.1 F3) in the

Operational Setup menu on the Remote Panel.

To use this feature, you need to activate the

PgmSpd option available from the

secondary menu in PGM/PRV mode. For more information, refer to the section

‘PgmSpd/VarMax’, on page 26.

How to Play Back a Clip

To play back a clip, proceed as follows:
1. Store a clip.
2. Recall the defined clip which will be played, the corresponding

F_ key lights red.

3. Press the

PLAY key or use the lever to start playing back the clip,

9.2.5

Recall and Playback of Growing Clips

You can recall and play growing clips, i.e. clips that are in the process of being created on

a disk.
As long as the OUT point of a growing clip is not available on the EVS server, the LED

corresponding to the growing clip location blinks green when it is called and red when it is

loaded on the Remote Panel. The clip LED will no longer blink as soon as both IN and

OUT points are available on the EVS server.
If the play reaches the end of the available material, the play will freeze until new material

is available for playout. When new material is available, the play resumes.
When the OUT point of the clip is known, the remaining time is displayed.
When the OUT point of the clip is not known, the remaining time display switches to --:--:-

-:-- until the entire clip is copied.