Sort->tc, Search, Operational menu – EVS MulticamLSM Version 11.00 Operating Manual User Manual

Page 37: Cam a/ b /c /d, 2 operational menu

Multicam - Version 11.00 – Operating Manual

EVS Broadcast Equipment SA – April 2012

Issue

11.00.C

The Post-Roll mode works as follows depending on the element played:

•

When a clip is played, it will not stop on the Short OUT point, but will continue to play

through the Short OUT point by the Post-Roll duration defined in the

Setup Menu.

•

When a record train is played, the same will happen if the

Record trains OUTs

parameter is set to “Freeze” in the

Operational Setup menu (p.2.3 F1).

•

When a playlist is played, the Post-Roll will apply only to the last clip of the playlist.

Sort->TC

This function allows the operator to search for all clips that contain a particular timecode.

For more information on this function, refer to the section ‘Sort->TC’, on page 46.

This function allows the operator to search the database using keywords and ranking.

Refer to the chapter 10 “Keyword Management” on page 70 for further details.
To return to the operational menu, press the

MENU key from the Remote Panel.

6.1.2

Operational Menu

Rst Cam

Local

Sync Prv

2nd CTRL

Cam A

Cam B

Cam C

Cam D

CAM A/ B /C /D

PRV CTL is OFF, select the camera to assign to the PGM output. This camera key will

be highlighted in the menu.
If

PRV CTL is ON, select the camera to assign to the PRV output. This camera key will

be highlighted in the menu.

Note
In 5CAM configuration (5 recorder channels and 1 player channel) or when

loading a clip where CAM E or F exists, the operational menu will display: