EVS MulticamLSM Version 11.00 Operating Manual - Manual (Page 30)

Issue
11.00.C
Multicam - Version 11.00 – Operating Manual
EVS Broadcast Equipment SA – April 2012
20
4.2 Selection of Clip Banks and Playlists
SHIFT+ F1 - F9 = CLIPS BANK
This allows access to clip banks 1 through 9 within the clip page (1 to 10).
SHIFT+ F1
= BANK 1
SHIFT+ F2 = BANK 2, etc. (up to bank 9)
Once in the bank, selection of the F1 – F10 keys will call up the respective clips. If Recall
Clip Toggle is enabled in the Setup menu, pressing several times on the same F_ key
will call successively all camera angles of that clip.
The clip numbering system is as follows:
Example
Clip 547 where
• “5” refers to the clip page number (1 to 10).
• “4” refers to the clip bank (1 to 9)
• “7” refers to the clip number (1 to 10) inside the bank
Note
To identify remote clips when using the XNet SDTI network, the number of the
clip is followed by the number of the machine on the network. i.e. Clip 547B/04
SHIFT+F10
= playlist BANK
This combination of keys gives access to the playlists’ banks. There are 10 playlists
within each clip page. Selecting F1-F10 at this point calls up the corresponding playlist.
Example: Playlist 51 where
• “5” refers to the clip page
• “1” refers to the playlist number (1 to 10)
Note
• The playlist bank of page 10 is not available from the EVS remote, since it is
actually reserved for the EVS AVSP protocol (for Air Box and Air Edit).
• To identify remote playlists when using the XNet SDTI network, the number
of the playlist is followed by the number of the machine on the network, i.e.
Playlist 51/04