EVS MulticamLSM Version 11.00 Operating Manual - Manual (Page 41)

Multicam - Version 11.00 – Operating Manual
EVS Broadcast Equipment SA – April 2012
Issue
11.00.C
31
7.1.2 Operational Menu
The operational menu in Multi PGM mode gives access to the functions detailed in the
following paragraphs:
Rst Cam
This function restores the position of cameras on the active channels: CAM A on PGM1,
CAM B on PGM2, etc.
Note
When a clip/playlist is loaded on a channel, switching back to Live mode will
recall the record train, which was last used on that output. This avoids too
frequent uses of the Rst Cam function.
Sync To
This button allows you to synchronize the selected PGM in use with another one. Press
this button and then select the PGM to be used as a reference. This function is not
available with network trains.
2nd CTRL
This function allows the operator to swap the control of one or several play channels
between the EVS remote and a third-party controller. Both controllers receive
permanently the status of the channel(s), but only one controller at a time is able to
actually control a channel. The secondary controllers are defined in page T2.2 of the
Technical Setup menu.
Press this function to enter the
2nd CTRL menu, select the channels that you want to
pass to the secondary controller by pressing the corresponding A, B or C key, then press
D (DONE) to validate your selection. Do the same to bring the control of a channel back
to the EVS remote.