EVS MulticamLSM Version 11.00 Operating Manual - Manual (Page 104)

Issue
11.00.C
Multicam - Version 11.00 – Operating Manual
EVS Broadcast Equipment SA – April 2012
94
11.6 Naming a Playlist or an Element in a Playlist
You can name a playlist from the VGA Playlist Bank screen or from the VGA Playlist
screen.
11.6.1 How to Name a Playlist from the VGA Playlist Bank
Screen
To name a playlist from the VGA Playlist Bank screen, proceed as follows:
1. From the Clip screen, press
END to go to the Playlist Bank screen of the requested
page.
2. Press the down arrow several times until the playlist to name is selected.
3. Type the desired name on the keyboard.
It appears in the Name field at the bottom of the screen. Use to
delete the last character, or ESC to clear the entire field.
4. Press F1 to assign the new name to the current playlist.
The playlist name will appear in the title bar next to the playlist number.
11.6.2 How to Name the Current Playlist on the VGA
Playlist Screen
To name the current playlist from the VGA Playlist screen, proceed as follows:
1. Press the
F10 key on the keyboard to open the VGA Playlist screen.
The current playlist is displayed.
2. Type the desired name on the keyboard.
It appears in the Name field at the bottom of the screen. Use to
delete the last character, or ESC to clear the entire field.
3. Press SHIFT+F1 to assign the new name to the current playlist.
The playlist name will appear in the title bar next to the playlist number.
11.6.3 How to Name the Current Element in the Loaded
Playlist
Note
Naming the current element of the loaded playlist will affect the original clips.
This function is only available when the playlist is the current one in Playlist Edit mode
(PLST EDIT) or Playlist Playout mode (PLST DIFF) on the EVS Remote Panel.
To name the current element in the loaded playlist from the VGA Playlist screen, proceed
as follows:
1. Press the
F10 key on the keyboard to open the VGA Playlist screen.