EVS MulticamLSM Version 11.00 Operating Manual - Manual (Page 142)

Issue
11.00.C
Multicam - Version 11.00 – Operating Manual
EVS Broadcast Equipment SA – April 2012
132
11.17.4 How to Perform a Swap Audio Track in Manual
Mode
If the Manual mode is selected for the Swap audio tracks parameter value in the
Operational Setup menu (p.3.2 F4), the swap operates in a similar way but asks the
operator which track to swap when setting the swap points.
Step 1
First the operator is being asked to select the original track:
• In 2-Track mode: you select between the tracks 1,2 or MENU to cancel.
• In 4-Track mode: you select among the tracks 1 to 4, or MENU to cancel.
• In 8-Track mode: you select among the tracks 1 to 8, or MENU to cancel.
• In 16-Track mode: you select among the tracks 1 to 16, or MENU to cancel. The
tracks 1-8 are displayed on a 1 st page and the tracks 9-16 are available via F10 on a
2 nd page.
The function keys are used to select the track to change.
Step 2
When the choice is made, the operator selects by which track the selected one has to be
replaced:
• In 2-Track mode: you select the new track between 1, 2 or 0.
• In 4-Track mode: you select the new track among 1 to 4, or 0
• In 8-Track mode: you select the new track among 1 to 8, or 0
• In 16-Track mode: you select the new track among 1 to 16, or 0. The tracks 1-8 are
displayed on a 1 st page and the tracks 9-16 are available via F10 on a 2 nd page.
Several swap points can be set on the same timecode (e.g.: 1 -> 3, 2 -> 4).
Note
Selecting
track 0 will mute the output until the next swap point or the end of
the clip.
11.17.5 Deleting Swap Points
When the operator is on a swap point, pressing CLEAR+IN/OUT deletes the current swap
point. All swap points for that timecode are deleted.
When the operator is not on a swap point, pressing CLEAR+IN/OUT brings up a
confirmation message to delete all swap points for the current clip.
11.17.6 Navigating Among Swap Points
When the operator is in Swap mode, the previous swap point can be reached by pressing