Next, Skip, Edit – EVS MulticamLSM Version 11.00 Operating Manual User Manual

Page 108: Main menu in playlist edit mode, Introduction, Edit all, 1 main menu in playlist edit mode

Issue

11.00.C

Multicam - Version 11.00 – Operating Manual

EVS Broadcast Equipment SA – April 2012

While the playlist is rolling on air, selecting the

Next function will start the transition of the

next clip with the transition effect listed on the playlist. This can be used if a clip is running

too long and it is necessary to shorten up the playing time.

Skip

While the playlist is rolling, the next clip in the sequence is always displayed on the PRV

screen. The

Skip function allows the operator to discard clips before they go on-air. The

clip that will be «skipped» is the one displayed on the PRV screen. This function does not

remove the clip from the playlist, but it simply allows it to be skipped during playback.

Edit

Selecting the

Edit function gets the user back to the Playlist Edit mode.

11.9

Overview of Editing Functions in Playlist Edit

Mode

The following section presents the various editing functions available from the main and

secondary Playlist Edit Mode.

11.9.1

Main Menu in Playlist Edit Mode

Introduction

The main menu in the Playlist Edit mode is available when you select the location of the

requested playlist, and press

PLST on the Remote Panel:

Effect

Edit All

Insert

Speed

FX Dur

Delete

In the Playlist Edit mode, the first frame of the playlist element loaded (highlighted on the

Remote Panel LCD display) can be seen on the PGM. To change any of the options on a

clip, simply browse to the requested clip, then select a function from the menu displayed

above and use the control lever to adjust to the desired value (when applicable).

Edit All

If you want to edit all clips of the playlist at the same time, select

Edit All (SHIFT+D)

before you perform the requested editing action with one of the following playlist

commands:

Speed, Effect, FX Dur.