Garmin G1000 Piper PA32 - Manual (Page 414)

190-00692-00 Rev. B Garmin G1000 Pilot’s Guide for Piper PA32 A-8
APPENDIX A
MESSAGE ADVISORY ALERTS
Alerts Window Message Audio Alert
PFD FAN FAIL – The cooling fan for the PFD is inoperative.
None MFD FAN FAIL – The cooling fan for the MFD is inoperative.
GIA FAN FAIL – The cooling fan for the GIAs is inoperative.
MFD & PFD MESSAGE ADVISORIES
Message Comments
DATA LOST – Pilot stored data was
lost. Recheck settings. The pilot profile data was lost. System reverts to default pilot profile and settings.
The pilot may reconfigure the MFD & PFD with preferred settings, if desired.
XTALK ERROR – A flight display
crosstalk error has occurred. The MFD and PFD are not communicating with each other. The G1000 system
should be serviced.
PFD1 SERVICE – PFD1 needs service.
Return unit for repair.
The PFD and/or MFD self-test has detected a problem. The G1000 system should
be serviced.
MFD1 SERVICE – MFD1 needs
service. Return unit for repair.
MANIFEST – PFD1 software
mismatch. Communication halted.
The PFD and/or MFD has incorrect software installed. The G1000 system should
be serviced.
MANIFEST – MFD1 software
mismatch. Communication halted.
PFD1 CONFIG – PFD1 configuration
error. Config service req’d.
The PFD configuration settings do not match backup configuration memory. The
G1000 system should be serviced.
MFD1 CONFIG – MFD1 configuration
error. Config service req’d. The MFD configuration settings do not match backup configuration memory. The
G1000 system should be serviced.
SW MISMATCH – GDU software
version mismatch. Xtalk is off. The MFD and PFD have different software versions installed. The G1000 system
should be serviced.
PFD1 COOLING – PFD1 has poor
cooling. Reducing power usage.
The PFD and/or MFD is overheating and is reducing power consumption by
dimming the display. If problem persists, the G1000 system should be serviced.
MFD1 COOLING – MFD1 has poor
cooling. Reducing power usage.
PFD1 “KEY” KEYSTK – Key is stuck.
A key is stuck on the PFD and/or MFD bezel. Attempt to free the stuck key by
pressing it several times. The G1000 system should be serviced if the problem
persists.
MFD1 “KEY” KEYSTK – Key is stuck.
CNFG MODULE – PFD1 configuration
module is inoperative. The PFD1 configuration module backup memory has failed. The G1000 system
should be serviced.
PFD1 VOLTAGE – PFD1 has low
voltage. Reducing power usage
The PFD and/or MFD voltage is low. The G1000 system should be serviced.
MFD1 VOLTAGE – MFD1 has low
voltage. Reducing power usage