Accusys ExaRAID GUI - Manual (Page 340)

Appendix
D-51
• Controller (In Dual-Controller Configuration)
Event ID 0x2425
Type CONTROLLER Severity WARNING Parameters Controller ID
Message Bad block on primary system flash over 70% in controller y
Description
The amount of bad blocks is over 70% of the table that is used to
remap bad blocks.
Advice
Check if there are any hardware hazards that lead to bad
blocks. This flash chip is close to fail.
Event ID 0x2426
Type CONTROLLER Severity WARNING Parameters Controller ID
Message Bad block on secondary system flash over 70% in controller y
Description
The amount of bad blocks is over 70% of the table that is used to
remap bad blocks.
Advice
Check if there are any hardware hazards that lead to bad
blocks. This flash chip is close to fail.
Event ID 0x242e
Type CONTROLLER Severity ERROR Parameters Controller ID
Message Controller x failed
Description
One of the controllers failed, was removed, or powered off, while
the other controller remains working. This happens only in dual-
controller configuration.
Advice
Check if the power supply is stable. Replace with a new control-
ler.
Event ID 0x242f
Type CONTROLLER Severity ERROR Parameters Controller ID
Message Controller x returned
Description The failed controller has been replaced and back to work.