Accusys ExaRAID GUI - Manual (Page 127)

Using the LCD Console
3-4
3.2.3 Emergent info
When an emergent event occurs, you can read the message on the LCD.
This state is held until every event is confirmed. See the function buttons as
below.
UP/DOWN: Scroll up/down the message.
ENT: Confirm (clear) the message. (not supported in current version.)
ESC: Enter the menu (password may be required).
Line 1 shows messages, and Line 2 shows the disk status. The displayed
emergent info is listed below:
3.2.4 Background task messages
Background tasks and their process percentages are displayed in Line 1.
Line 2 shows the disk status. Message formats are listed in the following.
Variables:
xx.yy : xx is the DG identifier; yy is the LD identifier.
dgx : DG identifier.
zz / HDD z : HDD identifier.
xx.x% : The progress of task (with percentage estimate)
Emergent Info Message Note
Voltage failure Voltage Failure
Power failure Power Failure
Fan failure Fan Failure
Temperature sensor
failure Temp Failure Temperature warning is not
included.
BBM failure BBM Failure Only when BBM is present.
Disk SMART warning SMART Warning
Disk BBR error Disk BBR Error
DG with degraded LD
and no rebuild task DG+Degraded LD
DG with faulty LD DG+Faulty LD
UPS On Batt UPS On Batt Only when upsconfig is on.
UPS connection is lost UPS Con Lost Only when upsconfig is on.
UPS should be replaced UPS RB Only when upsconfig is on.
UPS is overload UPS Overload Only when upsconfig is on.
UPS is off UPS Off Only when upsconfig is on.
Table 3-2 List of emergent messages