Accusys ExaRAID GUI - Manual (Page 318)

Appendix
D-29
• SMART disk self tests
Event ID 0x081c
Type DISK Severity WARNING Parameters
Chip ID,
Controller ID
Message Reset disk i/f chip x in controller y
Description
The controller y resets chip x that failed to execute commands
properly. This could be a transient error due to unstable channel,
heavy traffic, or malfunctioning hard disks. The controller will
resume normal operations of the chip after reset; however, this
could result in performance drop of the disks attached to the disk
ports of this chip.
Advice
If this event occurs often, check the disk connectivity, check
power supply to disks, or replace with a new disk.
Event ID 0x081d
Type DISK Severity FATAL Parameters
Chip ID,
Controller ID
Message Disk i/f chip x in controller y failed
Description
The controller y cannot execute commands properly on chip x
after all appropriate recovery procedures were conducted. This
could be the result of unstable power supply to the system. All
disks controlled by the chip will fail.
Advice
Check power supply, replace with a new controller, or contact
local sales or support office.
Event ID 0x081f
Type DISK Severity ERROR Parameters
Disk Chan-
nel ID, Con-
troller ID,
Register
value
Message Disk channel x in controller y PCI Error cause register: z
Description The controller y has detected error in the disk channel.
Advice
Check if the power supply is stable. Contact local sales or sup-
port office.
Event ID 0x0807
Type DISK Severity INFO Parameters Disk ID
Message SHT DST on HDDx started
Description hddx started SMART short device self test routine.
Advice None