Accusys ExaRAID GUI - Manual (Page 330)

Appendix
D-41
SAS
• Hosts
• Link
Event ID 0x300c
Type HOST Severity INFO Parameters
Host WWPN,
Host Port ID
Message Host x detected on host port y
Description
The controller detected host x on host port y. The host can start
access the controller over the host port.
Advice None
Event ID 0x300d
Type HOST Severity INFO Parameters
Host Port ID,
phy ID
Message Host port x phy y link up
Description
The link on the host port x phy y had been built by the controller
successfully, and data transferring can be started.
Advice None
Event ID 0x300e
Type HOST Severity NOTICE Parameters
Host Port ID,
phy ID
Message Host port x phy y link down
Description
The link on the host port x phy y had been turned down by the
controller, and data transferring was posed. This happens when
the host port was disconnected from host HBA or switch because
of removing/powering down/resetting the host or switch, or
removing the cables.
Advice
If the link unexpectedly disconnects, or it happens continuously
during host access, check the host connectivity, or contact local
sales or support office.