Section 16.11 supplemental output devices – NewTek TriCaster 2 Elite (3 RU) User Manual
Page 191

P a g e | 173
FIGURE 214
•
Checkmark channels 2, 3 and 4 in the column below
In 1
(see Figure 214). This routes sound from
the first incoming Skype caller to all
Aux 1
output channels
except
channel 1.
•
Open the audio configuration pane
Input 14
and, in the
Routing
tab, clear the
Aux 1
matrix.
FIGURE 215
•
This time, checkmark channels 1, 3 and 4 in the column below
In 1
. This routes sound from the second
incoming Skype caller to all
Aux 1
output channels
except
channel 2.
•
Repeat the steps above for audio inputs 15 and 16, omitting the
Aux 1
checkmarks under
In 1
for
channels 3 and 4, respectively.
That’s it –
you’ve got the perfect mix minus configuration for return to your
four Skype callers, using a single NDI output.
SECTION 16.11
SUPPLEMENTAL OUTPUT DEVICES
TriCaster features two additional menus are provided at the bottom of the
Routing
tab, under the heading
Supplemental Output Device
.
The left-most menu in this group lists any add-on output devices detected by
the system, and also a list of multichannel audio-only NDI outputs options.
For example, ‘transmit’ channels from Audinate’s Dante network audio
protocol will be listed here if you have installed Dante Virtual Sound Card
software. Or, in similar fashion, you may have installed AES67 drivers.
The audio connections on the motherboard are also listed here.
FIGURE 216