NewTek TriCaster 2 Elite (3 RU) - Manual (Page 154)

P a g e | 136
1. First, connect the camera’s output to a Switcher input – see Section 8.1.
2. Next you must configure the control connection to the camera by selecting its type.
o Since the default Connection type in this group is NDI , you can skip this step for an NDI
camera, which eliminates all of the settings you would otherwise need to configure.
FIGURE 169
o For non- NDI sources, use the
Connection menu to choose
the correct PTZ protocol for
your device, and enter other
data as required for that
protocol.
Having performed these steps, you are ready
to expand and use the
PTZ Presets control
group in the next tab, labeled PTZ .
12.1.2
PTZ OPERATIONS
In the PTZ tab, a set of manual Pan/Tilt, Zoom,
Focus and Iris controls sits just beneath a
large Presets bin. Drag the mouse on these
controls to make manual adjustments.
Speed controls, including SLOW , MEDIUM and
FAST presets along with a numeric speed
control allow you to modify the speed with
which presets are applied.
FIGURE 170