Ricoh PJ WU6181N 6200-Lumen WUXGA LCD Projector (No Lens) - Manual (Page 42)

27
2. Projecting an Image (Basic Operation)
❽
Turning off the Projector
To turn off the projector:
Eternet
1. First, press the (POWER) button on the projector cabinet
or the STANDBY button on the remote control.
The [POWER OFF / ARE YOU SURE ? / CARBON SAVINGS- SES-
SION 0.000[g-CO2]] message will appear.
2. Secondly, press the ENTER button or press the (POWER)
or the STANDBY button again.
The lamp will go off and the power supply will be cut. At this
point, if there are no input signals, the projector will go into the
standby mode after about 10 seconds. When in standby mode,
the POWER indicator will light red and the STATUS indicator will
light off when [NORMAL] is selected for [STANDBY MODE].
Power On
Steady blue light
Standby
Steady red light
Press twice
CAUTION:
Parts of the projector may become temporarily heated if the projector is turned off with the POWER button or if the AC power
supply is disconnected during normal projector operation.
Use caution when picking up the projector.
NOTE:
• While the POWER indicator is blinking blue in short cycles, the power cannot be turned off.
• You cannot turn off the power for 60 seconds immediately after turning it on and displaying an image.
• Do not unplug the power cord from the projector or from the power outlet while an image is being projected. Doing so could deteriorate the projector’s AC IN terminal
or the power plug’s contact. To turn off the AC power while an image is being projected, use the power strip’s switch, the breaker, etc.
• Do not disconnect the AC power supply to the projector within 10 seconds of making adjustment or setting changes and closing the menu. Doing so can cause loss of
adjustments and settings.