Ricoh PJ WU6181N 6200-Lumen WUXGA LCD Projector (No Lens) - Manual (Page 143)

128
5. Using On-Screen Menu
Turning On the Projector by Detecting Input Signal [AUTO POWER ON SELECT]
Under the condition of [NETWORK STANDBY], the projector automatically detects and projects synchronizing signal input from the
selected terminals among Computer, HDMI1/2, DisplayPort by this function.
OFF ....................................AUTO POWER ON SELECT function becomes inactive.
HDMI1, HDMI2, DisplayPort, COMPUTER
.............................................When the projector detects the computer signal input from the selected terminal, automatically it will be
turned ON and will project the computer screen.
NOTE:
• If you want to activate this AUTO POWER ON SELECT function after powering OFF the projector, interrupt signal from input terminals or pull out the computer cable from
the projector and wait for over 3 seconds and then input signal from the selected terminal. In case computer signal is continuously input to the projector, however the
projector is turned OFF and is in the transition to NETWORK STANDBY mode, it will keep NETWORK STANDBY mode and will not be turned ON automatically. In addition,
if signal from HDMI1/2, DisplayPort is continuously input to the projector, the projector may be turned ON again automatically based on the setting of external devices
even if the projector is turned OFF and in the condition of NETWORK STANDBY mode.
• This function is not activated either by component signal input from the computer screen input terminal or computer signal as Sync on Green and Composite Sync.
Enabling Power Management [AUTO POWER OFF]
When this option is selected you can enable the projector to automatically turn off (at the selected time: 0:05, 0:10, 0:15, 0:20,
0:30, 1:00) if there is no signal received by any input or if no operation is performed.
NOTE:
• [AUTO POWER OFF] works even when the viewer or network is being projected.
• When the [STANDBY MODE] is set to [NETWORK STANDBY] , [AUTO POWER OFF] will turn grey in color and [0:15] will be selected compulsorily.
Using Off Timer [OFF TIMER]
1. Select your desired time between 30 minutes and 16 hours: OFF, 0:30, 1:00, 2:00, 4:00, 8:00, 12:00, 16:00.
2. Press the ENTER button on the remote control.
3. The remaining time starts counting down.
4. The projector will turn off after the countdown is complete.
NOTE:
• To cancel the preset time, set [OFF] for the preset time or turn off the power.
• When the remaining time reaches 3 minutes before the projector is turned off, the [THE PROJECTOR WILL TURN OFF WITHIN 3 MINUTES] message will be displayed on
the bottom of the screen.