Ricoh PJ WU6181N 6200-Lumen WUXGA LCD Projector (No Lens) User Manual

Page 11

Important Information

Clearance for Installing the Projector

Allow ample clearance between the projector and its surroundings as shown below.
The high temperature exhaust coming out of the device may be sucked into the device again.
Avoid installing the projector in a place where air movement from the HVAC is directed at the projector.
Heated air from the HVAC can be taken in by the projector's intake vent. If this happens, the temperature inside the projector will
rise too high causing the over-temperature protector to automatically turn off the projectors power.

Example 1 – If there are walls on both sides of the projector

20 cm/7.9" or greater

13 cm/5.1" or greater

Filter cover
(Intake vent)

Lamp cover

NOTE:
The drawing shows the proper clearance required for the front, back and top of the projector.

Example 2 – If there is a wall behind the projector.

10 cm/3.9" or greater

Exhaust vent

NOTE:
The drawing shows the proper clearance required for the back, sides and top of the projector.

Example 3 – In the case of portrait projection.

Filter cover

(Intake vent)

13 cm/5.1" or greater

NOTE:
• The drawing shows the proper clearance required for the front, back and top of the projector.
• See page

163

for an installation example on portrait projection.