Ricoh PJ WU6181N 6200-Lumen WUXGA LCD Projector (No Lens) - Manual (Page 136)

121
5. Using On-Screen Menu
WIRED LAN
PROFILES • The settings for using the built-in Ethernet port in the projector can
be recorded in the projector memory in two ways.
• Select [PROFILE 1] or [PROFILE 2] and then do settings for [DHCP]
and the other options.
After doing this, select [OK] and press the ENTER button. This will
store your settings in memory.
• To recall the settings from memory:
After selecting [PROFILE 1] or [PROFILE 2] from the [PROFILES] list.
Select [OK] and press the ENTER button.
• Select [DISABLE] when not connecting to a wired LAN
—
DHCP Place a check mark to automatically assign an IP address to the projector
from your DHCP server.
Clear this check box to register the IP address or subnet mask number
obtained from your network administrator. —
IP ADDRESS Set your IP address of the network connected to the projector when
[DHCP] is turned off. Up to 12 numeric char-
acters
SUBNET MASK Set your subnet mask number of the network connected to the projector
when [DHCP] is turned off. Up to 12 numeric char-
acters
GATEWAY Set the default gateway of the network connected to the projector when
[DHCP] is turned off. Up to 12 numeric char-
acters
AUTO DNS Place a check mark to automatically assign the IP address of your DNS
server connected to the projector from your DHCP server.
Clear this check box to set the IP address of your DNS server connected
to the projector. Up to 12 numeric char-
acters
DNS CONFIGURATION Set the IP address of your DNS server on the network connected to the
projector when [AUTO DNS] is cleared. Up to 12 numeric char-
acters
RECONNECT Retry to connect the projector to a network. Try this if you have changed
[PROFILES]. —