Wi-fi protected setup (wps) – Epson SureColor P8570DL 44" Wide-Format Dual Roll Printer with High-Capacity 1.6L Ink Pack System User Manual
Page 51
51
3. Select
Wi-Fi Direct
>
Start Setup
>
Start Setup
.
Wi-Fi Direct is enabled, and the Wi-Fi network name (SSID) and password are displayed.
Note:
If Wi-Fi Direct is already enabled, the network name (SSID), password, number of connected
devices, and general procedures for setting up other devices are displayed.
4. Use your computer or wireless device to select the Wi-Fi network name (SSID) displayed on the
LCD screen, then enter the password shown.
5. When a connection is established, select
Close
to finish.
6. Select
Close
on LCD screen to close the network connection settings screen.
7. Select the
home icon to exit.
You see the
Wi-Fi Direct icon on the LCD screen and should be able to connect to your product
directly from your computer or device, and then print. If you are printing from a computer, make sure
you installed the network software from the Epson website.
Note:
If you don't see the
Wi-Fi Direct icon on the LCD screen, you may have selected the wrong
network name or entered the password incorrectly. Repeat these steps to try again.
Any connected devices will be disconnected when you turn off the printer. To reconnect after turning the
printer back on, repeat these steps.
Parent topic:
Related references
Related tasks
Accessing the Web Config Utility
Wi-Fi Protected Setup (WPS)
If your network uses a WPS-enabled wireless router or access point, you can quickly connect your
product to the network using Wi-Fi Protected Setup (WPS).
Note:
To check if your router is WPS-enabled, look for a button labeled
WPS
on your router or access
point. If there is no hardware button, there may be a virtual WPS button in the software for the device.
Check your network product documentation for details.