Roland SPD-SX PRO Sampling Pad with 32GB Internal Memory - Manual (Page 53)

Customizing a kit (KIT EDIT 1)
53
MASTER EQ Settings
Here’s how to configure the settings for the four-band parametric equalizer (master EQ) that’s applied at the final stage of the
master out.
* The master EQ effects are not applied to sound that’s output from the DIRECT OUT jacks.
* If “Master Direct Sw” is set to “DIRECT” in OUTPUT (P.117), the master EQ effect is not applied to the sound coming from the
MASTER OUT jacks.
Parameter Value Explanation
Type (only LOW and HIGH)
SHELV (Shelving), PEAK
(MID1 and MID2: fixed to “PEAK”)
Selects how the equalizer effect works.
Q
0.5–16.0
(only when Type is set to “PEAK”)
Adjusts the bandwidth of the frequency region.
Higher values make the width more narrow.
Freq
20 Hz–1 kHz (LOW)
20 Hz–16 kHz (MID1, 2)
1k Hz–16 kHz (HIGH)
Adjusts the center frequency.
Gain -12–+12 dB Adjusts the amount of boost/cut.
Kit Volume -INF, -60.0–+6.0 dB Adjusts the volume of the kit.
Button Explanation
[F5] (ON/OFF) Turns the MASTER EQ on/off.
[F6] (DEFAULT) Restores the MASTER EQ settings to their default values.
Setting the Output Destination (OUTPUT ASSIGN)
On the OUTPUT ASSIGN screen, press the [F1]–[F5] buttons to select the parameters to configure.
The parameters are the same as those that are set in the OUTPUT/EFFECTS screen. On this OUTPUT ASSIGN screen, you can check
the parameters as a list.
PAD OUT (PAD OUTPUT)
Specifies the output destination for the pad audio.
1. Select the pad or trigger to set using the cursor [ г ] [ в ] buttons, and select the output destination using
the [-] [+] buttons.