Roland SPD-SX PRO Sampling Pad with 32GB Internal Memory - Manual (Page 109)

Configuring the Overall Settings for the SPD-SX PRO (SYSTEM)
109
Configuring the Overall MIDI Settings for the SPD-SX PRO (SYSTEM MIDI)
1. Select [MENU] Ó “SYSTEM”.
2. Use the cursor [ а ] [ б ] [ г ] [ в ] buttons to select “SYSTEM MIDI” and press the [ENTER] button.
The SYSTEM MIDI screen appears.
3. Use the [F1]–[F3] buttons to switch between settings screens.
Button Explanation
[F1] (BASIC) Basic settings
[F2] (CONTROL) Control settings
[F3] (SYNC) Synchronization settings
4. Use the cursor [ а ] [ б ] buttons to select a parameter, and then use the [-] [+] buttons to change the
setting.
BASIC
Parameter Value Explanation
MIDI Tx/Rx Sw OFF, ON Turns the transmitting/receiving of MIDI messages on/off.
Global MIDI Channel 1–16Ch Sets the transmit/receive channel.
Program Change Tx OFF, ON Sets whether program change messages are sent (on/off).
Program Change Rx OFF, ON Sets whether program change messages are received (on/off).
Soft Thru MIDI In
OFF, ON (MIDI OUT), ON
(USB MIDI), ON
(MIDI+USB)
Sets how the performance data from a MIDI device connected to the MIDI IN
connector of the SPD-SX PRO is transmitted to an external MIDI device.
OFF: Performance data received from the SPD-SX PRO’s MIDI IN connector will
not be sent to the MIDI OUT connector or the USB COMPUTER port.
ON (MIDI OUT): Performance data received from the SPD-SX PRO’s MIDI IN
connector will be sent to the MIDI OUT connector.
ON (USB MIDI): Performance data received from the device connected to the
SPD-SX PRO’s MIDI IN connector will be sent to the USB COMPUTER port.
ON (MIDI+USB): Performance data received from the device connected to the
SPD-SX PRO’s MIDI IN connector will be sent to the MIDI OUT connector and
the USB COMPUTER port.
Soft Thru USB MIDI In
OFF, ON Performance data from a computer connected to the SPD-SX PRO’s USB
COMPUTER port can be transmitted to a MIDI device connected to the MIDI
OUT connector.
OFF: Performance data received via the SPD-SX PRO’s USB COMPUTER port is
not transmitted to the MIDI OUT connector.
ON: Performance data received via the SPD-SX PRO’s USB COMPUTER port is
transmitted to the MIDI OUT connector.
Local Control
OFF, ON Connects (“ON”) or disconnects (“OFF”) the performance data from the pads
to/from the sound module of the SPD-SX PRO.
This should normally be set to “ON”. If this is “OFF”, the performance data from
the pads is not connected to the SPD-SX PRO’s sound generator section.
Device ID
17–32 Sets the device ID.
The setting described here is necessary only when you wish to transmit
separate data to two or more SPD-SX PRO units at the same time. Otherwise,
don’t change this setting.