Roland SPD-SX PRO Sampling Pad with 32GB Internal Memory - Manual (Page 51)

Customizing a kit (KIT EDIT 1)
51
Button Explanation
[F4] (CTRL PRE GATE) Turns the CTRL PRE GATE on/off.
[F5] (CTRL PREVIEW)
Turns the CTRL PREVIEW on/off.
When this is on, you can temporarily listen to just the control signal going through the side chain.
[F6] (ASSIGN) Shows the settings screen for the pad and trigger output destinations.
Reading the level meter
Level
meter
Explanation
CTRL IN
Control signal level for the side chain compressor (the signal level after applying the PRE GATE to the control signal
when CTRL PRE GATE is “ON”)
IN Side chain compressor input level
GR Side chain compressor gain reduction level
OUT Side chain compressor output level
MASTER EFFECT Settings
Here are the master effect settings that are applied to the final stage of the master out signal.
* The master effect is not applied to sound that’s output from the DIRECT OUT jacks.
* If “Master Direct Sw” is set to “DIRECT” in OUTPUT (P.117), the master effect is not applied to the sound coming from the
MASTER OUT jacks.
For each master effect type, one, two or more predetermined parameters are assigned to the [MASTER EFFECT] knob.
You only need to switch the MASTER EFFECT on and turn the [MASTER EFFECT] knob to apply the effect to the sound outputted
from MASTER OUT.
Parameter Value Explanation
Type
Ø Effect
List (P.151)
Sets the MASTER EFFECT type.
Level -INF–+6.0 dB Sets the effect output level.
(Effect
parameters)
Ø Effect
List (P.151)
Ø Effect List (P.151)
For each master effect type, the predetermined parameters are assigned to the [MASTER
EFFECT] knob.
(KNOB) is shown next to these parameters.
Button Explanation
[F6] (ON/OFF)
Turns the MASTER EFFECT on/off.
You can also set this using the MASTER EFFECT [ON/OFF] button.
Hold down the [SHIFT] button and press the MASTER EFFECT [ON/OFF] button to switch to the MASTER EFFECT screen.