Roland SPD-SX PRO Sampling Pad with 32GB Internal Memory - Manual (Page 107)

Configuring the Overall Settings for the SPD-SX PRO (SYSTEM)
107
SETUP
Sets the click volume, how the click plays and so forth.
Parameter Value Explanation
Click Mode
PLAY INTERNAL CLICK,
PLAY WAVE as CLICK, PLAY WAVE as CLICK-
TRACK
Selects the click mode.
PLAY INTERNAL CLICK: This mode uses the built-in click
sound.
PLAY WAVE as CLICK: This mode uses a preloaded wave or a
wave imported by the user.
If a waveform is selected with PLAY WAVE as CLICK, the
wave at the accent position does not sound. The wave only
sounds at the quarter note, eighth note, sixteenth note and
triplet timings.
PLAY WAVE as CLICK-TRACK: This mode uses the click track
wave imported by the user.
Click Sound (*1)
METRONOME, BEEP, WOOD BLOCK, STICKS,
CLAVES, AGOGO, TRIANGLE, TAMBOURINE,
BELL, CABASA
Selects the click sound.
Click Wave (*2)
00000 OFF, 00001 (Wave name)–20000
(Wave name)
Selects the type of click sound from the waves.
Click-Track Wave
(*3) 00000 OFF, 00001 (Wave name)–20000
(Wave name) Selects the type of click track sound from the waves imported
by the user.
Volume -INF, -60.0–+6.0 dB Sets the click volume.
Pan L15–CENTER–R15 Adjusts the pan (left-right balance) of the click sound.
Click Start Pad
(Range)
OFF, P1–9, T1–8, F1, F2 Selects the controller used to start the click.
The click starts once you strike the selected pad.
Select any pad you like, or specify a range of pads. (Example:
to make the click start when you strike either pad 1, 2 or 3, set
this to P1–P3.)
Pad Click Trig Type
When ONE-TIME, RETRIGGER, or
ALTERNATE Click Start Pad is “OFF”:--- Selects how the click operates when you strike a pad that’s set
as a click start pad.
ONE TIME: The click starts once you strike the pad.
RETRIGGER: The click restarts from the first beat every time
you strike the pad.
ALTERNATE: The click starts/stops with each strike of the pad.
Click-Track Loop
OFF, ON, --- (When “Click Mode” is set to a
value other than “PLAY WAVE as CLICK-
TRACK”)
Plays the wave you want to use as a click track, over and over
in a loop.
LED Reference
OFF, ON, --- (When “Click Mode” is set to
“PLAY WAVE as CLICK-TRACK”)
Sets whether the [CLICK] button blinks in time with the click
(ON) or does not blink (OFF).
*1 When Click Mode is “PLAY INTERNAL CLICK”
*2 When Click Mode is “PLAY WAVE as CLICK”
*3 When Click Mode is “PLAY WAVE as CLICK-TRACK”